Renault TRIBER 2024 - Unlocking; Seat belt reminder light (Driver;Front Passenger seats); Rear seat belt reminder

To Next Page

To Previous Page

SEAT BELTS

Getting to know your vehicle - 23

Unlocking

Press the button

on latch

and the

seat belt will be rewound by the inertia

reel. Hold by the buckle to make this

easier.

Seat belt reminder light (Driver/

Front Passenger seats)

Depending on the vehicle, it

comes on in the cluster when the igni-

tion is ON and goes off after few sec-

onds and if the driver’s and/or

passenger’s seat belt is not fastened.

When the vehicle is being driven, it

comes on and a beep sounds for ap-

proximately 2 minutes until the driver’s/

passenger seat belt is fastened.

an object placed on the

passenger seat may acti-

vate the warning light in

some cases, depending on the

vehicle.

Rear seat belt reminder

(Depending on the Vehicle)

The

graphic is displayed on the in-

strument panel in below two states,

This informs the driver fastening status

of each of the rear seat belts every

time:

– the ignition is switched on;

– Status of fastening or unfastening of

a rear seat belt.

Understanding the graphic

– indicator filled: seatbelt fastened;

– indicator unfilled: seatbelt unfas-

tened;

Depending on the vehicle, the

sym-

bol appears when the ignition is

switched ON, if a rear seat belt is

buckled state to unbuckled state or

any state change. When the vehicle

speed is less than approximately 12

mph (20 km/h), the

symbol appears

for at least 65 seconds.

When the vehicle speed reaches or

exceeds 12 mph (20 km/h), if one of

the rear seat belts is or becomes un-

fastened during the journey:

– a beep is emitted for 35 seconds ;

and

– the

symbol is displayed for at least

65 seconds and the symbol for the

seat concerned changes to unfilled.

Always make sure that the rear pas-

sengers are properly fastened in and

that the number of seat belts indicated

corresponds to the number of rear

seats occupied.