AUTOMATED MANUAL TRANSMISSION
3
Driving - 89
|
If any gear other than neutral is en-
gaged, N flashes on the display ; press
the brake pedal and place the lever in
position N. Start the engine.
NB: Do not attempt to start the engine
by pushing the vehicle if the battery is
flat (the display remains OFF when the
ignition is switched ON).
Under certain conditions, the engine
starter may take some time. Keep the
key in the starting position.
Exactly like a vehicle
equipped with a manual
gearbox, a vehicle
equipped with a sequen-
tial gearbox is unable to prevent
the vehicle from rolling on a slope
if the handbrake is not applied or
the brake pedal constantly not
pressed. The vehicle can be in
stationary place on an incline for
two seconds (Giving Driver
enough time to take his foot off
the brake & press the accelerator)
Once the vehicle is
switched to ignition ON po-
sition, the gearbox initial-
izes. This produces a light sound.
This is normal. Crank the engine
after three seconds.
Starting
Moving forwards (starting in neutral)
The gear display shows Neutral
With the brake pedal pressed, position
the selector lever to D.The letter A
(Automatic) appears on the cluster.
Release the brake pedal :
– The engine’s idle speed is sufficient
for parking manoeuvres.
– Accelerate gently to move forwards.
Start the engine, wait for
three seconds before se-
lecting D/R gears.
Avoid shifting reverse gear imme-
diately after starting the engine.
Reverse gear (from neutral, with the
vehicle stationary)
With the brake pedal pressed, position
the selector lever to R. The letter R ap-
pears on the display.
Release the brake pedal:
– The engine’s idle speed is sufficient
for parking manoeuvres.
– Accelerate gently to reverse.
There is a beep when reverse gear is
engaged.
You may shift from reverse gear to a
forwards gear by pushing the lever to
D once the vehicle is stationary.
Note : When the vehicle is stationary,
you must depress the brake pedal to
engage a gear. Otherwise, warning
light will come on.