PARKING DISTANCE CONTROL
3
|
92 - Driving
Operating principle
Ultrasonic sensors, fitted in the
vehicle’s rear bumper, measure the
distance between the vehicle and an
obstacle when reversing.
This measurement is indicated by
beeps which become more frequent
the closer you come to the obstacle,
until they become a continuous beep
when the vehicle is approximately 35
centimetres from the obstacle.
There is a beep when reverse gear is
engaged. If the beep sounds for a long
time (3 seconds), this signals an oper-
ating fault.
NB : ensure that the ultrasonic sen-
sors are not obscured (by dirt, mud,
snow, etc.).
Note :
Depending on the vehicle, the screen
1
shows the vehicle surroundings
alongside the beeps.
Operation :
When reverse gear is selected, most
objects which are less than approxi-
mately 1.20 metres from the rear of the
vehicle are detected, a beep sounds
and, depending on the vehicle, the dis-
play
1
comes on.
Operating faults
When the system detects an operating
fault, there will be a three-second con-
tinuous beep as a warning. Please
consult an authorised dealer.
To Next Page
Loading...
