BODYWORK MAINTENANCE
5
Maintenance - 131
|
proved by our Technical
Department :
– mechanical compo-
nents (e.g. : engine
compartment) ;
– underbody ;
– parts with hinges
(e.g. : inside the doors) ;
– painted plastic exter-
nal fittings (e.g. :
bumpers).
Doing this could give
rise to corrosion or oper-
ational faults.
Vehicles with a matte paint fin-
ish
This type of paint requires certain pre-
cautions.
You should do the following
Wash the vehicle by hand using plenty
of water, using a soft cloth or a gentle
sponge.
Do not do the following
Use wax-based products (polishing).
Rub too hard.
Wash the vehicle in a roller-type car
wash. Attach stickers to the paintwork
(risk of leaving marks).
Wash the vehicle using
a high-pressure cleaning
device.
Using a roller type car wash
Return the wiper stalk to the park
position.Check the mounting of exter-
nal accessories, additional lights and
rear view mirrors, and ensure that the
wiper blades are secured with adhe-
sive tape.
Remove the radio aerial mast if your
vehicle is fitted with this equipment.
Remember to remove the tape and re-
fit the antenna after washing.
Cleaning the headlights, sen-
sors and cameras
Use a soft cloth or cotton wool. If this
does not clean them properly, moisten
the cloth with soapy water, then wipe
clean with a soft damp cloth or cotton
wool.
Finally, carefully dry off with a soft dry
cloth.
Do not use cleaning products con
taining alcohol or utensils (e.g. : a
scraper).
To Next Page
Loading...
