CLOCK
2
Getting to know your vehicle - 55
|
Display A
To access the display
2
for setting the
time, press button
1
and Wait a few
seconds ; the hours and minutes will
begin to flash. You are now in setting
mode, press and hold button
1
.
Wait a few seconds, the minutes will
flash : repeatedly press or press and
hold button
1
to set the time. When
setting is complete, the hours and min-
utes remain displayed continuously for
2 seconds : your setting is registered.
You may change the display.
If the power supply is cut
(battery disconnected, sup-
ply wire cut, etc.), the clock
must be reset.
We recommend that you do not
adjust these settings while dri-
ving.
To Next Page
Loading...
