TAKE A BREAK REMINDER
3
Driving - 75
|
– Once switching ON the “Take A
Break” function and it will enter to the
Feature options.
– By pressing the switch
3
“SET Re-
set Time” function will appear on the
display.
– By pressing the switch
4
, it will enter
to the set reset time Mins selection.
– Customer can SET rest time (5Mins/
10Mins/15Mins) by using downwards
and upwards switch.
– Press the switch
4
OK to select the
Rest time.
– If any one of the setting parameters
(Distance/Time) threshold value
meets, by the time ”TAKE A BREAK”
message displayed on the instrument
panel continue for 30 seconds (alert
will disappear if user acknowledge with
in 30 seconds or vehicle speed reach-
es 0 km/h (0 mph)) and with 3 seconds
chime.
– It is advisable to stop as soon as
possible for a selected break time.
– If user not taken break after alert
message, this message will reappear
in every 30 minutes or 50km.
– The Take A Break warning continu-
ously monitors the parameters and can
provide several warnings per journey.
– The system resets every time the
engine is started.
The system resets when if exceeds the
rest time based on following condi-
tions.
– Engine idle condition, Vehicle speed
0 km/h (0 mph)
– Engine OFF.
– User need to ON the
function and by default the
function is OFF state
– Once the function ON, Remains
ON until OFF by user
To Next Page
Loading...
