TYRE PRESSURE LOSS WARNING
3
Driving - 83
|
This function is an addi-
tional driving aid.
The function does not
take the place of the dri-
ver. It cannot, therefore, under
any circumstances replace the
vigilance or the responsibility of
the driver.
Check the tyre pressures, includ-
ing the emergency spare wheel,
once a month.
Resetting the standard level for the
tyre pressures
It must be carried out while the vehi
cle is stopped :
– after each reinflation or readjustment
of the pressure of one of the tyres ;
– when the standard tyre pressure
needs to be changed to adapt to us-
age conditions (empty, carrying a load,
motorway driving, etc.) ;
– after changing a wheel ;
– after using the tyre inflation kit ;
– after switching the wheels of the
same axle (you must not switch be-
tween the front and rear wheels).
It should always be done after check-
ing the tyre pressure of all four tyres
when cold.
Resetting procedure
Ignition on, vehicle stationary:
– press button
B
briefly several times
to select the function “ SET TYRE
PRESSURE " is displayed ON the In-
strument panel.
– press and hold (around 3 seconds)
button
B
to start initialisation. If the
“SET ” warning light flashes or
text message on the Instrument panel
"TPMS ONGOING " for approximately
5 seconds accompanied by a constant
illumination of the SET warning
light, this indicates that the request for
reinitialisation of the tyre pressure ref-
erence value has been correctly regis-
tered.
Reinitialisation is carried out after a
few minutes’ driving.
Resetting procedure
(depending on vehicle)
Ignition on, vehicle stationary:
– press button
A
briefly several times
to select the function “ TYRE PRES-
SURE SET " is displayed ON the In-
strument panel.
– press and hold OK switch
B
(around
3 seconds) to start initialization. Then
confirm " RESET " tyre pressure mes-
sage will appear. Select OK to reset
the tyre pressure. If warning
light along with are turned off.
This indicates that the request for re-
To Next Page
Loading...
