Renishaw MP10 - Default Chapter; Table of Contents

Contents
1-1
Software requirements ...................... 1-23
Typical probe cycles ..........................1-24
System flow charts.............................1-26
SERVICE and MAINTENANCE........1-29
Weak link for styli with steel shaft ...... 1-29
Diaphragm inspection ........................1-30
Diaphragm replacement ....................1-31
SCREW TORQUE VALUES .............1-32
FAULT FINDING ...............................1-34
APPENDIX 1
ADAPTOR and EXTENSIONS ..........1-37
APPENDIX 2 PSU3 ..........................1-38
APPENDIX 3 OMM............................1-38
APPENDIX 4 MI 12 ........................... 1-39
APPENDIX 5 OMI..............................1-40
PARTS LIST ......................................1-42
SYSTEM INSTALLATION
Typical probe systems .......................1-2
Two OMMs and remote indicator ......1-3
Performance envelope ...................... 1-4
System performance..........................1-8
MP10 features ...................................1-9
MP10 dimensions ..............................1-10
Modes of operation ............................1-11
Options setting switch ........................1-12
Enhanced trigger circuit .....................1-12
Battery covers and battery.................1-13
Stylus spring pressure adjustment .... 1-15
Stylus on-centre adjustment ..............1-16
Probe/shank mounting.......................1-16
OPERATION
LEDs ..................................................1-2
Switch-on/switch-off ...........................1-11
Probe moves......................................1-22