en
Fixscreen
®
100 Slim (F)
48
7 • Maintenance
The product does not need much maintenance, but for years of enjoyment, we advise the following:
• If the fabric becomes wet in a sudden storm, you can still roll it up and unroll it later to dry when
the weather is better. However, avoid having the wet fabric rolled up for more than three days to
prevent formation of mould and spots.
• Before cleaning, remove any loose dirt with a brush or vacuum cleaner. You can then use a
cleaning product (avoid caustic products) and warm water to remove the remaining dirt. Always
rinse the fabric after cleaning. Avoid cleaning in full sunlight: if soapy water dries quickly, it can
leave spots on the fabric.
Do not use aggressive abrasives.
• Crystal screen may only be cleaned with clean lukewarm water (± 30°C)
• If anodised or enamelled profiles become dirty, they can be cleaned with warm water and
a gentle-acting cleaning product. Never use aggressive products, abrasive sponges or other
abrasive media.We also advise against using high-pressure equipment.
• Swivelling or rotating parts should be lubricated annually. Use a dry lubricant for this (PTFE Flex
Lube (G6002796)).
• After cleaning (remove twigs and leaves), plastic sliding sleeves can be lubricated with a dry
lubricant (PTFE Flex Lube (G6002796)).
• Frequently control your product on twigs, leaves, bird nests, ets. and remove them.
Maintain the product “as a good keeper”.
• As the manufacturer, we recommend having a regular technical inspection by your installer:
Annually at public utility building and at your private home.
• Always use original parts from the manufacturer.
Important to know:
• The main connection should be made by a qualified electrician in accordance with applicable
standards.
• Minor colour variations may occur during the manufacturing process between the colour guides
and the profiles of the sunprotection screen. There may also be minor colour differences between
components and profiles.
• The fabric may exhibit slight colour nuances and imperfections.
• Because the fabric is rolled up, it can form folds or creases.
• Fabrics that contain crystal windows can expand, shrink and/or show folds or creases caused
by differences in temperature or fabric tension.
• Over time, the colour of the fabric / crystal window may fade slightly, depending on the chosen
colour and design.
• In the case of straight screens, where the fabric hangs down vertically because of the weight of
the bottom rail or a tensioning system, wrinkles can form in the fabric depending on the type of
screen
(See also our warranty certificate
*
)
* This information does not replace the warranty certificate.
To Next Page
Loading...