Renson Fixscreen 100 Slim - Closing the Head Box and Sealing the Side Guiding Channels

en
Fixscreen
®
100 Slim (F)
43
Slide the fabric into the HPVC
inner rail.
Be sure to observe the correct
direction of the side guiding
channels!
Make sure the V cut-out is
positioned at the top of the
side guiding channel and the
clicker
➄
is positioned at the
bottom of the side guiding
channel.
With a single screen or a coupled screen: close the head box
with the removable profile below the head box and fix this
to the reversed U-brackets on both sides of the head box, by
means of the 2 screws near the supporting endpieces with a
torx screwdriver.
3.4 • Closing the head box and sealing the side guiding channels
In case of a deep side guiding
channel, the front part is
supported by black clips
➆
,
applied each 400 mm.
35
110 110
4862 4862
35 35 35
110
35
110
35
110
35
35
6248 6248
35
ø5
➎
Insert the inner rail back into the guiding channel.
➏
- Put the removable profile
of the side guiding channel
into place and screw it
down.
- Check that the fabric slides
freely into the inner rail
without any tension.
- When adjusting the motor,
set fixed end points at the
top and bottom.
Attention:
The bottom bar is retractable. So pay attention that
the bottom bar does not hit the fabric on the fabric set.