Response Electronics miGuard G5 - System Timing and Sound Settings; Entry;Exit Delay Time Adjustment; Alarm Volume and Siren Duration

25
26
Setting alarm volume and duration
Both alarm volume and duration of the siren can be adjusted in this menu.
Siren volume (0 Mute, 1 Low, 2 High):
2
Siren ringing time(1- 9min):
5
Text ‘12’ to the Control Panel. Copy the message and adjust the volume (‘0, 1 or 2’) of the
siren and the duration of the siren as shown below.
Siren volume (0 Mute, 1 Low, 2 High):
0
Siren ringing time (1-9 min):
3
Change entry/exit delay time
The system can be armed with a time delay. When a delay time is set you will hear a
beep every second as a warning of this delay. The beep will go faster in the last 15
seconds.(0-300 sec.):
Set delay time successfully.
Set siren volume and ringing time successfully.
Text ‘11’ to the Control Panel.
11
Entry and exit delay time
(0-300 sec.):
30
Entry and exit delay time
(0-300 sec.):
40
12
After sending the message you will receive the following message from the Control Panel to
confirm the new settings:
After sending the message you will receive the following message from the Control Panel to
confirm the new settings:
Copy the message adjust the time as example below
Copy the message adjust the settings as example below.