What to do if RESQTEC X2 arms will not open or close?
If the RESQTEC Spreader arms won't open or close when connected to a power unit, first ensure the product is correctly connected. Then, verify that the appropriate valves on the power unit are open. Finally, check that the power unit has sufficient hydraulic oil and gasoline.
Manual contains safety messages pointing out potential hazards and damage risks.
Safety precautions for operating Resqtec rescue equipment safely.
Hazards and precautions before installing and using the product.
Manual correspondence with product and service booklet.
Lists product types covered by this manual.
Introduction to the manual and Resqtec product.
Details on the design and intended use of Resqtec spreaders.
Identifies key components of the spreader.
Lists available Resqtec spreader models and accessories.
Instructions for checking equipment for damage upon receipt.
Pre-operational checks for the spreader and its components.
How to operate the spreader using the control handle.
Information on the operating pressure and fluid compatibility.
Details on the standard NEO1 quick action couplers.
Step-by-step guide to connecting the NEO1 coupler.
Step-by-step guide to disconnecting the NEO1 coupler.
Step-by-step guide to connecting the STD coupler.
Step-by-step guide to disconnecting the STD coupler.
Procedure to release pressure for easier connection.
Detailed steps for operating the spreader arms.
Instructions on how to rotate the spreader jaws.
Guide on attaching chains and shackles to the spreader.
Technical specifications for the spreader in SI units.
Technical specifications for the spreader in Imperial units.
Force specifications for spreaders in SI units.
Force specifications for spreaders in Imperial units.
Technical drawings of spreaders in SI units.
Technical drawings of spreaders in Imperial units.
Steps for maintaining the equipment after each use.
Recommendations for regular maintenance of the equipment.
Requirements for annual inspection by a trained technician.
Guidelines for proper storage of the equipment.
Procedures for decommissioning and recycling the product.
Common issues and their solutions for the spreader.
Information on the product's warranty terms and conditions.
Legal information, rights reserved, and liability disclaimers.
Addresses and contact details for Resqtec offices.
To Next Page
General