RESQTEC X2 - General Operating Instructions; Initial Use; Preparation Before Use

USER MANUAL SPREADER X-SERIES
08
RESQTEC Manual SPREADER X-series (DM064K08)
4. GENERAL OPERATING INSTRUCTIONS
4.1. INITIAL USE
When receiving your equipment check for any sign of damage to the box, and report it to your distributor/supplier as damage could have
occurred during shipping. Unpack in upright position and check the product for damage. To make sure the product conforms to your
specications,

check

the
product

details

on

the
label.
CHECK THE EQUIPMENT FOR EXTERNAL DAMAGE. NOTIFY THE DISTRIBUTOR/SUPPLIER IMMEDIATELY IF ANY
DAMAGE IS FOUND. DO NOT USE DAMAGED EQUIPMENT UNDER ANY CIRCUMSTANCE!
In general we distinguish a couple of different types of operations;
• Connecting the Resqtec NEO1 coupler
• Disconnecting the Resqtec NEO1 coupler
• Connecting the Resqtec STD coupler
• Disconnecting the Resqtec STD coupler
• Using the pressure release
• Operating the product
• Rotating jaws
• Attaching chains and shackles
4.2. PREPARATION BEFORE USE
• Check the arms of the product. Do not use if they exhibit major
damage and/ or do not function as intended.
• See chapter 6 for further information.
• Check the operation of the dead-man’s valve. It should return to its
neutral position when released.
• See chapter 6 for further information.
•Checkthecarryinghandle.Itmustbermlyxed. • See chapter 6 for further information.
• Check the protection covers. They must be present and undamaged. • See chapter 6 for further information.