RESQTEC X2 - Annual Maintenance and Storage; Annual Maintenance; Recommended Storage; Decommissioning & Recycling

29
USER MANUAL SPREADER X-SERIES
RESQTEC Manual SPREADER X-series (DM064K08)
6.3. ANNUAL MAINTENANCE
Many years of safe use is guaranteed if the product is properly cared for and maintained. To this end the product must
be inspected at least once a year. This must be carried out by a service technician trained by Resqtec who possesses
the necessary tools and testing equipment.
It is also possible for you, the user, to carry out maintenance yourself. In the context of your own safety and the product liability it is necessary
that

appropriate

training

should

be

undertaken

rst.
Your

distributor/supplier

can

advise
you

on

this

and/or

attend
to

the
annual

maintenance

on

a contract basis, if desired.
STRUCTURALLY DAMAGED AND/OR BROKEN EQUIPMENT MUST NEVER BE USED DURING RESCUE OPERATIONS.
THIS MAY RESULT IN VERY DANGEROUS AND POTENTIALLY HARMFUL SITUATIONS. DO NOT ATTEMPT!
If structural damage and/or broken equipment or parts are discovered, immediately contact your distributor/supplier or the manufacturer
.
DO NOT REPAIR ANY BROKEN EQUIPMENT AND/OR PARTS. ALWAYS CONTACT YOUR DISTRIBUTOR /SUPPLIER OR THE
MANUFACTURER.
Repairing equipment and/or parts causes your warranty to expire. Always contact your distributor/supplier or the manufacturer when broken
parts

and/or

equipment

are

discovered.
Broken

equipment

and/or

parts

can

then

be

sent

to

certied
service

centers.

6.4. RECOMMENDED STORAGE
The following storage recommendations counts for all spreaders and its accessories:
• Do not close the arms of the spreader completely, otherwise excessive pressure might develop
• Ensure that the equipment is completely depressurized
• If needed apply an anti-corrosion layer on the jaws and protection plates as described in chapter 6.1
• Store out of direct sunlight
• Store the equipment in a dry, well-ventilated area:
6.5. DECOMMISSIONING & RECYCLING
The various parts can be re-used at the end of their service life. Collect the hydraulic oil and dispose of it separately. Refer to the MSDS that
was supplied with your product and/or follow local regulations on disposal.
The products consist of steel, aluminum, neoprene (seals) and plastic. The product does not contain any pressurized components. Consult your
distributor/supplier for further information on recycling.
Recommended storage temperature range 10°C - 30°C / 50°F - 86°F
Recommended storage relative humidity 0 – 60%