27
USER MANUAL SPREADER X-SERIES
RESQTEC Manual SPREADER X-series (DM064K08)
6.
Check the couplers and caps for dirt.
Clean them if necessary.
• Use dry, paper cloth.
Do NOT use any oil.
7.
Check coupler functioning after cleaning.
• Connect and disconnect the coupler at
least 3 times. If the coupler is not functioning
properly, contact your Resqtec
distributor/supplier.
8.
After heavy use, CRC SP 400 can be used
to ensure the jaws are protected against
corrosion.
• Only apply on the jaws and protection
plates.
• Spray and clean with dry paper cloth.
• Clean any other parts that may have
attracted some coating in the process.
Read instructions carefully before
using CRC SP 400.
ATTENTION! IF YOU DECIDE THE JAWS NEED TO BE COATED FOR ANTI-CORROSION PURPOSES, ONLY USE CRC SP 400!
OTHER PRODUCTS ARE KNOWN TO HAVE NEGATIVE EFFECTS ON THE LUBRICANT USED IN YOUR EQUIPMENT. OTHER
PRODUCTS ALSO DO NOT HAVE THE HIGH PROTECTION GRADE THAT CRC SP 400 PROVIDES.
To Next Page
Loading...