: Positioning the ring and disc
• Fill grinding material into the space (RZ) between the grinding jar wall (MW)
and the inner ring (RE).
– For best grinding results, the area (RS) between the inner ring (RE) and the
disc (SC) must remain empty.
: Filling area of the grinding jar
• Remove any residual grinding material on the grinding jar wall, the inner ring
and the disc, e.g. using a brush.
• Check whether the lid seal has been inserted.
• Close the grinding jar with the lid.
• Open the clamping lever (SH).
• Push the grinding jar into the support.
To Next Page
Loading...
