– The Save parameters menu opens and the dark line cursor is placed on
Program.
NOTICE
You can change the active program or any other program.
• Press the operating button (F) to activate the program selection.
• By rotating the operating button (F), switch to the desired storage location.
• Press the operating button (F) to exit the storage location selection.
• Set the desired grinding parameters.
• To finish, select either
- Save to save the settings or
- Back to cancel without saving.
– You will then return to the Program level.
NOTICE
It is not possible to start a program that has not been saved.
5.16.4 Delete program
In this menu you can delete the stored parameters of any program.
NOTICE
Only the parameters stored in the respective program are deleted. The program is still saved in
the designated location.
• By rotating the operating button (F), switch to the Delete program menu
item.
• Press the operating button (F).
– The Delete program menu opens and the dark line cursor is placed on
Program.
• Press the operating button (F) to activate program selection.
• By rotating the operating button (F), switch to the desired program.
• Press the operating button (F) to exit the program selection.
• To finish, select either
- Delete top delete settings or
- Back to cancel without saving.
– You will then return to the Program level.
5.17 Basic settings
NOTICE
No grinding can be started while the basic settings menu is active.
5.17.1 Automatic opening
In this menu you can set whether the grinding chamber lid opens automatically when grinding
has finished or is only opened when the button is pressed.
If the function is switched off, the following pictogram is shown on the display as confirmation.
: Pictogram for automatic opening
5.17.2 Language
You can select the menu language here. After selecting the language and pressing the
operating button, the entire menu structure is displayed in your language.
NOTICE
The language menu is displayed when the device is switched on for the first time.
To Next Page
Loading...
