Retsch RS 200 - Preparing the Grinding Process

Operating the Device
27
5.8.1.1 Tungsten carbide (TC) grinding sets
Only use tungsten carbide grinding sets in the RS200 at speeds of ≤ 1200min
-1
.
Do not use any grinding jars with 4 identical drilled holes (13mm in diameter) on the bottom.
Grinding jar material
Number of drilled holes
Drilled hole 25mm
Drilled hole 13mm
Reworking possible
No reworking required
TC (old)
2
-
2
Yes
-
Agate (old)
4
-
4
Yes
-
TC (new)
3
1
2
-
Ok
Steel (all types);
zirconium oxide
2
-
2
-
Ok
Agate (new)
4
2
2
-
Ok
Fig.
16
: Grinding jar information on device label
5.8.2 Preparing the grinding process
Place a disc and a ring on the grinding jar.
• Position the ring and disc as shown in the diagram.
RS200 Max. speed with TC
≤ 1200min
-1