– Language
– Brightness
– Date
– Time
– Acoustic warning signal
– Service
5.15 Manual Mode
5.15.1 Grinding duration
00:01 to 99:59 (minutes : seconds)
5.15.2 Speed
700 to 1500 rpm
5.15.3 Start in
00:00:01 to 99:59:59 (hours : minutes : seconds)
You can adjust a countdown to the starting of the device here.
• Press the STOP button to cancel the countdown.
5.15.4 Save parameters
You can save previously set parameters such as grinding duration and speed in a memory
here.
• Set the desired parameters.
• By rotating the operating button (F), switch to the Save parameters menu
item.
• Press the operating button (F).
– The Save parameters menu opens and the dark line cursor is placed on
Program.
• Press the operating button (F) to select a storage location for the program.
• By rotating the operating button (F), switch to the desired storage location.
• Press the operating button (F) to exit the storage location selection.
• Select either
- Save to save the settings or
- Back to cancel without saving.
5.16 Programme Mode
5.16.1 Grinding duration
Display of the saved grinding duration:
00:01 to 99:59 (minutes : seconds)
5.16.2 Speed
Display of the saved speed:
700 to 1500 rpm
5.16.3 Change program
You can change the saved parameters of any program in this menu.
• By rotating the operating button (F), switch to the Change program menu
item.
• Press the operating button (F).
To Next Page
Loading...
