Retsch RS 200 - Menu Structure and Mode Selection; Overview of the Menu Structure; Selecting an Operating Mode

Operating the Device
36
5.13 Menu structure
Complete overview of all menu items:
MANUAL OPERATING
MODE
Grinding duration
Speed
Start in
Start in:
Screen message:
Press STOP to cancel
Back
Save parameters
Program
Save
Back
PROGRAM [01 - 10]
Grinding duration
Speed
Change program
Program
Grinding duration
Speed
Save
Back
Delete program
Program
Delete
Back
BASIC SETTINGS
Automatic opening
Language
Brightness
Date
Time
Acoustic signal
Service
Operating hours
Software version of display
Software version of controller
Update software
Display
Software update will be started
automatically
Controller
Software update will be started
automatically
Back
Back
5.14 Operating modes
You can select the following operating modes using the menu navigation (C1):
5.14.1.1 Manual operating mode
If this function has been set, you can call up and change all parameters and functions at any
time. This is also possible during milling.
5.14.1.2 Program 01 to 10
The previously set parameters, grinding duration and speed can be saved in the memory in
Programs 01 to 10.
5.14.1.3 Basic settings
The following device settings can be adjusted in this settings menu:
– Automatic opening