Retsch RS 200 - Page 48

Lid closing
automatic ......................................................... 21
Lid closing mechanism ....................................... 25
Locking the transport rollers ............................... 17
LpAeq.................................................................. 21
LWA .................................................................... 21
M
Mains frequency ................................................. 13
Maintenance ................................................. 41, 42
Manual mode ...................................................... 37
Manual operating mode ...................................... 36
Manufacturer’s address ...................................... 13
Menu structure .................................................... 36
Moderate or mild injury ......................................... 7
Motor rotation speed ........................................... 20
Mounting the transport screws ........................... 16
N
Noise levels ........................................................ 21
Noise measurement ............................................ 21
Notes on the manual ............................................. 6
Number of fuses ................................................. 13
O
Operating elements and displays ....................... 24
Operating hours .................................................. 39
Operating modes ................................................ 36
Operating the device ........................................... 22
Operation ............................................................ 15
Overview Table of the Operating Elements and
the Display ...................................................... 24
Overview table of the parts of the device ........... 24
P
Packaging ........................................................... 12
Part number ........................................................ 13
Positioning the ring and disc ............................... 28
Power failure ....................................................... 25
Power version ..................................................... 13
Program 01 to 10 ............................................... 36
Programme mode ............................................... 37
property damage ................................................... 7
Protective earth ................................................... 14
Protective equipment .......................................... 21
R
Rated power ....................................................... 20
Regulations for the place of installation .............. 14
Repair ................................................................... 9
Replacing the machine fuses ............................. 41
Required floor space ........................................... 21
Residual current protection device ..................... 14
Return
for service and maintenance ........................... 45
Return goods dispatch note ................................ 45
S
Safety warnings .................................................... 7
Save parameters ................................................ 37
Selection bar ...................................................... 33
Serial number ..................................................... 13
serious injury ........................................................ 7
Service ............................................................... 39
Service Address ................................................... 9
Setting the language .......................................... 38
shielded cable .................................................... 14
Software
update ............................................................ 39
Software version of controller ............................ 39
Software version of display ................................ 39
Sound level meter .............................................. 21
Sound power level ............................................. 21
Speed ................................................................. 37
Start in ................................................................ 37
Suppressor capacitor wiring .............................. 14
Symbols in the Display Unit ............................... 33
T
Target group ........................................................ 8
Technical data .................................................... 18
Temperature fluctuation and condensed water . 12
Time ................................................................... 39
Transport ................................................ 12, 15, 17
Transport lock
removing from the device ............................... 15
Transport lock .................................................... 17
Transportation lock ............................................ 15
removing ......................................................... 17
Tripping current .................................................. 14
Type plate .......................................................... 14
description ...................................................... 13
Type plate lettering ............................................ 13
U
Unscrewing the transport lock from the transport
pallet ............................................................... 15
Use of the device for the intended purpose ....... 18
V
Version of operating software ............................ 39
View of the back of the device ........................... 23
View of the control panel ................................... 24
View of the device from the front ....................... 22
View of the menu on the display unit ................. 33
Views of the device ............................................ 22
W
Wear....................................................... 20, 26, 41
Wearing parts ..................................................... 44
Weight ................................................................ 21
Width .................................................................. 21
Workplace-related emissions value ................... 21
wrong language ................................................. 34
Y
Year of production .............................................. 13