REXON RHP-530E - Memory Operation; Instant Memory Write; Memory Channel Recall

I Duplex On/Off
The duplex feature is intended to allow the user to transmit on
a Com band frequency to a Flight Service Station and receive
over a Nav band frequency.
(1) Type the desired Com band frequency.
(2) Type the desired Nav band frequency.
(3) Press €D button, LCD shows H then press the [9 PUP)
button to enter duplex mode. IDUPI appears.
(4) Press PTT to transmit, LCD shows Com frequency; Re-
lease PTT, LCD shows Nav frequency
(5) To exit duplex, repeat step (3) and (DUP)indicator will dis-
appear.
7. Memory Operation
Up to 100 Memory channel is available, 00 through 99
•instant Memory Write
(1) Type desired frequency on keypad.
(2) Press€D button, LCD shows H then press theli**]
button to enter memory mode.
(3) Press (3^/(2) button or the dial selector or type number
on keypad to select desired store number. Press the
(S? button twice ( If users don't want to add names).
^ NOTE: In the memory mode when the memory numbers
are flashing, it indicates the channel is empty.
•Memory Channel Recall
(1) Press IB! button for 2 seconds until Q is flashing then
press l
8MW
) button to enter memory channel or long press
the C3p button for 2 seconds to enter memory channel.
Press (3L)/(S?) button or the dial selector or type num-
bers on keypad to select desired memory channel num-
ber.
Press QE9 button to quit memory channel mode.
(2)
(3)
| Memory Names
To name 6-characters at memory channel.
(1) Type desired frequency on keypad.
(2) Press €H button, LCD shows H then press theSj*]
button to enter memory mode.
(3) Press CJ£)/(W) button or the dial selector or type num-
bers on keypad to select desired store number. Press the
QS^ button.
(4) There are no any characters showing on LCD.
(5) Press (3)/t?) button or keypad or the dial selector to
select from English alphabet.
(6) If no any selections entered, it will change to next charac-
ters in 1 second.
(7) Press Q?p button to save and quit memory name mode.