3. Charging The Battery
(1) Connect the jack of AC adaptor into the socket of the
charging cradle.
(2) Plug the AC adaptor into the power outlet. The built-in
green LED of cradle will glow.
(3) Insert the transceiver into the cradle. The built-in red LED
of cradle will flash.
(4) Rapid charger finishes charging for approximately 2 hours,
the built-in full LED of cradle will glow.
CAUTION
ffl
NOTE:
Make sure the transceiver is turned off while charg-
ing.
^
NOTE:
Do not forget to remove the transceiver from the
charger when the battery is fully-charged.
To Next Page
Loading...
