REXON RHP-530E - B Com Band Scanning; Nav Band Scanning; B Com;Nav All Band Scanning; B Weather Channel Scanning

(2) Press (2£)/(S) button or the dial selector to set BUSY-S
or PAUS-S.
(3) Press Q1P button to save and quit the menu list.
|Com Band Scanning
(1) Press QE9 button to verify you are in airband mode.
(2) Press Ci button then press 0S9 button, it starts scan-
ning from 118.000MHz to 136.975MHz.
(3) During scanning, press (j$V(3) to change scan direc-
tion.
(4) Press QS9 button to quit com band scanning.
|Nav Band Scanning
(1) Press v3E? button to verify you are in airband mode.
(2) Press €D button then press (z5B button, it starts scan-
ning from 108.000-117.975MHz.
(3) During scanning, press (^)/(^t) to change scan direc-
tion.
(4) Press ^5E? button to quit navigation band scanning.
•Com/Nav All Band Scanning
(1) Press QB9 button to verify you are in airband mode.
(2) Press €DI button for 2 seconds, until Q symbol is flash-
ing then press QE? button. Transceiver starts scanning
from 108.000~136.975MHz
(3) During scanning, press (3V(Sb to change scan direc-
tion.
(4) Press QH9 button to quit all band scanning.
•Weather Channel Scanning
(1) Press ^Ul button then press the 111 button to enter
weather channel mode.
(2) Press WM button then press QK2 button, it starts scan-
ning.
(3) Press CS9 button to quit weather channel scanning.
•Memory Channel Scanning
(1) Press (MB button for 2 seconds until Q is flashing then
press I ••»! button to enter memory channel.
(2) Type desired memory number or rotate the selector or
press (3)/(3) to select.
(3) Press QE9 button to quit memory channel scanning.
• Sub-group scan : Press^DI button then press 059 but-
ton, the scanning ranges from channel xO to x9; for instance
: when memory channel stays in channel 15, the scanning
ranges from 10 to 19; when memory channel stays in chan-
nel 42, the scanning ranges from 40 to 49.
• All-group scan : Press flD button for 2 seconds then
press ^3D button, scanning ranges from channel 00 to 99
•PTT Disable
(1) Press €01 button for 2 seconds until Q is flashing then
press 15P-W[ button to disable the PTT function.
(2) Repeat Step (1) to enable the PTT function.
H