RF-Star nRF52832 - Broadcast

nRF52832
www.szrfstar.com V1.3 - Sep., 2020
Shenzhen RF-star Technology Co., Ltd. Page 24 of 58
OK
Remark
This device status display is enabled.
AT+STATUS=
Function
Set display state of device status.
Example
AT+STATUS=0
Return Value
OK
Remark
Disable device status display.
Take effect immediately, do not save after power off.
• Broadcast
AT+ADS=?
Function
Query parameter range of this command.
Example
AT+ADS=?
Return Value
AT+ADS=<0,1>,<0,1>,<10,10240>
OK
Remark
This command has three parameters.
Parameter 1: Set broadcast status (0: Disable. 1: Enable, take effect immediately).
Parameter 2: Set broadcast mode (0: Non-connectable. 1: Connectable, take effect after restart).
Parameter 3: Set broadcast interval (in ms, take effect after restart).
AT+ADS?
Function
Query broadcast parameters.
Example
AT+ADS?
Return Value
AT+ADS=1,1,200
OK
Remark
Enable broadcast.
Device is connectable.
Broadcast interval is 200 ms.
AT+ADS=
Function
Set broadcast parameters.
Example
AT+ADS=1, 0, 500
Return Value
OK