RichAuto A122 - Page 36

Add: 5F
, No.4 building, No 4. Yard, life Rd, life science park,
Tel：010-53275118 Fax
：
Note: the blue fonts
section is
Setting method：Press“
press ”
,and then select
9. Input list:
View 8 input
home signals, no.4 to 8 have not defined any
10. Output list:
View 8 outputs signals’ configuration. No.1 is spindle forward on/off
signal, No. 4 is spindle inversion on/off signal, no.6 is run lamp signal.
11. Input disable:
Enable or disable input signals. User can select disable from X5 to
X8 port signals if there ha
12. G code setup:
Set special commands reading settings in G code file, change
according to real demand.
Note: The blue characters
section
Set function
SpdLimit None/
PausePkup NoPick/
SpdlAtP Ramian
ScaleFast None
/Affect
Manual Trad/
Step
Pretrt None/
QuryPara
None/
Beijing RichAuto S&T Co., Ltd
, No.4 building, No 4. Yard, life Rd, life science park,
Beiqing St., Changping d
ist.
：
010-53275110/53275111 Web site：
www.richnc.com.cn
section is
the default configuration of the system.
”、“
”move cursor to where users want to modify
,and then select
the required function，and press “
”to save.
View 8 input
s
signals’ configuration. No.1 to 3 are X,Y,Z axis returning
home signals, no.4 to 8 have not defined any
signal.
View 8 outputs signals’ configuration. No.1 is spindle forward on/off
signal, No. 4 is spindle inversion on/off signal, no.6 is run lamp signal.
Enable or disable input signals. User can select disable from X5 to
X8 port signals if there ha
ve no signal wires.
Set special commands reading settings in G code file, change
according to real demand.
(See Attachment 1)
section
is the system default attribute.
StrtHome Query/Auto/
Zonly/
SpdLimit None/
Limit FileSort ByCopy/
ByName/
PausePkup NoPick/
Pickup CopyWork off/on
SpdlAtP Ramian
/Stop RetOrgPZ Pick Z/Z stop
/Affect
TolstAct Pickup/
Origin
Step
PausRstr All/only Z
Pretrt None/
Parse NI Mode Full/Small
None/
Query SpdOutpt Polar/
SglAng/
Attribute of G code
F Read Ign F/Read F
AbsCntr Off/On
T Read Read T/Ign T
Spindle NTLLG/FORCE/INSTR
Filter JD None/Filter
S Read Ign S/Read S
Read G54 Ign G54/ Read G54
Read G49 Ign G49/ Read G49
Read G40 Ign G40/ Read G40
Gcode Head Skip /NoSkip
G83 Space 0.00000
Beijing RichAuto S&T Co., Ltd
ist.
Beijing, China
www.richnc.com.cn
32
”move cursor to where users want to modify
，
”to save.
signals’ configuration. No.1 to 3 are X,Y,Z axis returning
View 8 outputs signals’ configuration. No.1 is spindle forward on/off
signal, No. 4 is spindle inversion on/off signal, no.6 is run lamp signal.
Enable or disable input signals. User can select disable from X5 to
Set special commands reading settings in G code file, change
Zonly/
None
ByName/
NoSort
Origin
SglAng/
Mulang