RichAuto A122 - Page 52

Add: 5F
, No.4 building, No 4. Yard, life Rd, life science park,
Tel：010-53275118 Fax
：
ground, causing the crystal process
(2) Users connect
high voltage power supply
5. The screen display
“spindle on”
“spindle off”，
actually the spindle on
Analysis and solutions：
(1)
There is something wrong with wires.
(2)
The output level definition is wrong.
6. Screen is not bright after handle power
Analysis and solutions：
(1)
The power supply voltage is too big or the chip
positive and negative of the power oppositely.
(2)
The power supply is damaged.
(3) 50-
pin data cable damaged.
(4) Handle 50-
pin interface damage.

PS.4. Making
For Lathe processing file, users can u
etc.
as the tool to make graphs.
and so on).
1)
Example of lathe drawing
Red
line refers to the direction of X axis and the knife feed depth distance during
processing.
Green
line represents Y axis direction, refers to the working length during processing.
Beijing RichAuto S&T Co., Ltd
, No.4 building, No 4. Yard, life Rd, life science park,
Beiqing St., Changping d
ist.
：
010-53275110/53275111 Web site：
www.richnc.com.cn
ground, causing the crystal process
or damaged. Depot repair.
high voltage power supply
，Depot Repair.
“spindle on”
，actually the spindle off，
the screen display
actually the spindle on
There is something wrong with wires.
Organize your wires.
The output level definition is wrong.
Modification correct output level definition.
6. Screen is not bright after handle power
-on
The power supply voltage is too big or the chip
is broken because
operator makes
positive and negative of the power oppositely.
Depot repair.
The power supply is damaged.
Replace the power supply.
pin data cable damaged.
Replace the data line.
pin interface damage.
Depot repair.
PS.4. Making
Graphs
For Lathe processing file, users can u
se the modeling software such as
CAD,
as the tool to make graphs.
And save as DXF format(2000,2004，
R12
Example of lathe drawing
line refers to the direction of X axis and the knife feed depth distance during
line represents Y axis direction, refers to the working length during processing.
Beijing RichAuto S&T Co., Ltd
ist.
Beijing, China
www.richnc.com.cn
48
the screen display
Modification correct output level definition.
operator makes
CAD,
Rhinoceros
R12
，R20 version
line refers to the direction of X axis and the knife feed depth distance during
line represents Y axis direction, refers to the working length during processing.