RichAuto A122 - Page 53

Add: 5F
, No.4 building, No 4. Yard, life Rd, life science park,
Tel：010-53275118 Fax
：
Note: the start point must be (0,0)
The image file name should be named
system automatically calls the prefix file named D as lathe processing file in turning
& gridding loop processing. E.g.: D1.dxf
2)
Example of spiral machining drawing
Truncate in the wood work piece image at the
and save as a new file (as shown in the following picture)
Beijing RichAuto S&T Co., Ltd
, No.4 building, No 4. Yard, life Rd, life science park,
Beiqing St., Changping d
ist.
：
010-53275110/53275111 Web site：
www.richnc.com.cn
Note: the start point must be (0,0)
The image file name should be named
with letter D at the beginning of it. The
system automatically calls the prefix file named D as lathe processing file in turning
& gridding loop processing. E.g.: D1.dxf
Example of spiral machining drawing
Truncate in the wood work piece image at the
position where needs to do spiral machining,
and save as a new file (as shown in the following picture)
Beijing RichAuto S&T Co., Ltd
ist.
Beijing, China
www.richnc.com.cn
49
with letter D at the beginning of it. The
system automatically calls the prefix file named D as lathe processing file in turning
position where needs to do spiral machining,