50
4. Ensure electrode is completely dry before using the treatment.
Check with patient to ensure the patient is not allergic to any
cleaning solution used to clean the rubber electrodes, prior to
administering treatment.
5. The sponge pads should be washed in warm water, using a
household cleaner. After washing, they must be rinsed with clear
water, thoroughly drained and then dried. Damaged sponge pads
should be replaced.
6. Between uses, store the electrodes in the reusable bag and in a
cool dry place.
CAUTION:
1. The self-adhesive electrodes are intended for single patient use only.
2. If the electrodes
DO NOT
adhere completely to the patient’s skin, it may
cause a slight shock.
3. If irritation occurs, discontinue use and consult your clinician.
4. Always use the electrodes with CE mark, or are legally marketed in the
United States under an approved 510(K) procedure
6.4 Cleaning the Lead Wires and Cables
1. Periodically wipe the lead wires clean with a cloth dampened in a mild
soap solution, and then gently wipe them dry. Use of rubbing alcohol
on the lead wires will damage the insulation and dramatically shorten
their life. It is the manufacturer’s recommendation to replace lead
wires every six months
6.5 Maintenance
1. Maintenance and all repairs should only be carried out by an
authorized agency. The manufacturer will not be held responsible for
the results of maintenance or repairs completed by any unauthorized
person(s).
2. Opening of the equipment by unauthorized agencies is not allowed
and will terminate any claim to warranty.
To Next Page
Loading...
