57
11. ELECTROMAGNETIC COMPATIBILITY (EMC) TABLES
IMPORTANT INFORMATION REGARDING ELECTROMAGNETIC
COMPATIBILITY (EMC)
1. The device needs special precautions regarding electromagnetic compatibility
(EMC) and needs to be installed and put into service according to the EMC
information supplied in this manual.
2. Care must be taken when operating this device adjacent to or stacked with other
equipment. Potential electromagnetic or other interference could occur to this or
other equipment. Try to minimize this interference by not using other equipment in
conjunction with it.
3. The performance of the device was determined to be essential performance. This
device has been thoroughly to assure proper performance and operation.
Guidance and manufacturer’s declaration - electromagnetic emissions
The device is intended for use in the electromagnetic environment specified below.
The customer or the user assures that it is used in such an environment.
Emissions Test Compliance Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1 The device uses RF energy only for
its internal function. Therefore, its RF
emissions are very low and are not likely
to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B The device is suitable for use in all
establishments including domestic and
those directly connected to the public
low-voltage power supply network that
supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage
fluctuations/flicker
emissions IEC
61000-3-3
Applicable
To Next Page
Loading...
