Ricoh AC205 - Page 217

T ROUBLESHOOTING 9.14
[No Answer] The receiving fax
machine has not
answered after several
redial attempts.
Try again. Make sure that the
receiving machine is operational.
No. Not
Assigned
The one-touch or speed
dial location you tried to
use has no number
assigned to it.
Dial the number manually using
the number keypad or assign the
number. For storing a number, see
“Automatic Dialing” on page 7.19.
Invalid Cartridge
Or
No Cartridge
You have used an
unauthorized cartridge.
You must use a approved
cartridge.
No. Not
Available
You have tried to delete
the number for a delayed
fax job.
Verify the number to be deleted
and try again.
Or, delete the number after the
delayed fax job has been sent.
[No Paper]
Add Paper
The paper in the paper
tray has run out.
Load paper in the paper tray. See
page 2.7.
Operation
Not Assigned
You are doing the Add/
Cancel operation, but
there are no jobs
waiting.
Check the display to see if there
are any scheduled jobs. The
display should indicate them in
Standby mode; for example,
Delay Fax.
Paper Jam 0
Open/Close Door
Paper has jammed in the
feeding area of the paper
tray.
Clear the jam. See page 9.5 and
page 9.6.
Paper Jam 1
Open/Close Door
Paper has jammed in the
fuser area.
Clear the jam. See page 9.7.
Paper Jam 2
Check Inside
Paper has jammed in the
paper exit area.
Clear the jam. See page 9.9.
[Power Failure] Power has turned off
then on and the
machine’s memory has
not been saved.
The job which you were trying to
do before the power failure must
be completely re-done.
Priority Fax
Function Full
The priority fax jobs
queue is full.
Cancel unnecessary priority fax
jobs.
[Retry Redial?] The machine is waiting
for a specified time
interval to redial a
previously busy station.
You can press
Enter to
immediately redial, or
Clear/
Stop
to cancel the redial
operation.
Display Meaning Suggested solutions