Administrator Guide Page 3-7
Network Installation Using Internet Services
Ethernet
Use these instructions to set the speed rate for Ethernet using Web Image Monitor Type 103:
To complete the installation of the Type 103, perform these steps:
¾ Enable Web Image Monitor Type 103 (see “Enabling Internet Services” on page 3-5).
¾ At the Web Image Monitor Type 103 Home Page for the Type 103, select the [Network
Settings] tab.
¾ In the Network Settings, select [General].
¾ Choose the appropriate [Speed Rate].
¾ Click the [Apply] button to implement any changes.
NOTE: Click the [Undo] button to cancel any changes made and return to the
previous values.
1
2
3
4
5
To Next Page
Loading...
