Administrator Guide Page 1-3
Basic Network Installation
Basic TCP/IP Settings
Before the printer can be used on the network, the TCP/IP addresses need to be entered.
These can be entered automatically using Dynamic Host Configuration Protocol (DHCP) or
Bootstrap Protocol (BOOTP) or entered manually. To enter the addresses manually, you need
to obtain the following:
¾ TCP/IP Address
¾ Gateway Address
¾ Subnet Mask Address
¾ Primary DNS Server Address
Installation Procedure
There are three stages required to install the Type 103 in a TCP/IP networking environment:
¾ Network Communication Setup
This requires the Type 103 to be setup for TCP/IP.
¾ Workstation Setup
This requires the Workstations in the networking environment to be
configured to communicate with the Type 103.
¾ Test P rint
A print job should be submitted to ensure the Type 103 has been installed
and configured correctly.
To Next Page
Loading...
