Ricoh AC205 - Static Addressing

U SING Y OUR M ACHINE ON A N ETWORK A.6
6 Press Enter to save the selection.
7 Press Clear/Stop to return to Standby mode.
Configuring TCP/IP
Your machine can be set up with a variety of TCP/IP networks
information, such as an IP address, a Subnet Mask, and a
Gatway. There are several ways in which your machine can be
assigned a TCP/IP address, depending on your network.
• Static Addressing: A TCP/IP address is assigned manually
by the system administrator.
• Dynamic Addressing BOOTP/DHCP (default): A TCP/IP
address is assigned automatically by the server.
N OTE : Before configuring the TCP/IP, you need to set network
protocol to TCP/IP.
Static Addressing
To enter the TCP/IP address from your machine’s control panel,
take the following steps:
1 Press Menu until you see “Network Setup” on the top line
of the display.
2 Press the scroll button ( or ) until “Config Network”
displays on the bottom line.
3 Press Enter to access the menu.
The first available menu item, “TCP/IP,” appears on the
bottom line.
4 Press Enter .
The first available menu item, “Manual,” appears on the
bottom line.
5 Press Enter .
The first available menu item, “IP Address,” displays on the
bottom line.
6 Press Enter to access the IP Address menu.