User Tools (System Settings)
34
3
❒ Refer to the chart below when selecting the mode for the paper thickness.
*1
Out of guarantee
❒ Depending on paper type and operating conditions, toner fusing condi-
tions vary. To improve toner fusing, change the setting mode to 3→2→1.
❒ When using thin, soft, or limp paper, toner fusing may appear wrinkled or
the image may be blurred. If this happens, change the setting to mode
3→4→5.
❒ When translucent paper modes 1 or 2 are selected, and you change the pa-
per type from plain or film to translucent, it may take longer for the ma-
chine to get ready for copying (up to two minutes).
❖
❖❖
❖ Orig. Size Detect
You can specify the scanning area when detecting the size of an original.
• Metric version:
• A Series
• JIS B Series (JIS:Japanese Industrial Standard)
• Inch version:
• Architecture
• Engineering
Note
❒ Default:
• Metric version: A Series
• Inch version: Engineering
❒ When you change the setting, the following changes are made to the
UserAutoR/E Orig. setting in User Tools (Copier Features).
Mode12345
Paper type
Plain paper 110 g/m
2
(29.3 lb)
90 g/m
2
(23.9 lb)
70 g/m
2
(Standard
mode)
(18.6 lb)
60 g/m
2
or
less
(15.9 lb)
Limp paper
Translucent
paper
70 – 90 g/m
2
(18.6 – 29.3
lb)
70 – 80 g/m
2
(18.6 – 21.3
lb)(Stand-
ard mode)
70 – 80 g/m
2
(18.6 – 21.3
lb)
50 – 70 g/m
2
(13.3 – 18.6
lb)
Hemmed
paper
*1
* If the paper wrinkles when using mode 2,
try using mode 1.
Film 0.07 mm –
0.095 mm
(2.8 Mil – 3.7
Mil)
0.07 mm –
0.095 mm
(2.8 Mil – 3.7
Mil)
0.07 mm –
0.095 mm
(2.8 Mil – 3.7
Mil) (Stand-
ard mode)
0.07 mm –
0.095 mm
(2.8 Mil – 3.7
Mil) (Stand-
ard mode)
—
NeptuneC1_GBzen_F_FM_pre.book Page 34 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
