Settings You Can Change with User Tools
37
3
Note
❒ Default:
• Metric version:
• Bypass tray: Under 420mm Width
• Paper roll 1, 2:
• A series: 841mm (paper roll 1), 420mm (paper roll 2)
• Cut paper tray:
• A series: A4K
• Inch version:
• Bypass tray: Under 17" Width
• Paper roll 1, 2:
• Engineering: 34" (paper roll 1), 17" (paper roll 2)
• Cut paper tray:
• Engineering: 12
×
18K
❖
❖❖
❖ Tray Paper Type
You can specify the type of paper in a paper tray.
Specify the type of paper in each of the paper trays (bypass tray, paper roll
tray 1, paper roll tray 2, and cut paper tray.)
• Plain
• Translucent
• Film
• Recycled
Note
❒ Default: Plain
❒ You can specify plain or recycled paper for the cut paper tray.
❖
❖❖
❖ Orig. Edge Hold
When large size originals, such as A0(E)K or A1(D)K, are delivered to the
lower tray, you can have the machine gather the trailing edge of the original
so that it does not fall to the floor. This setting specifies whether or not to use
that function.
• On (Always)
• On (Specify)
• Off
Note
❒ Default: Off
❒ To use the function, select [On (Always)] or [On (Specify)]. To not use the func-
tion, select [Off].
❒ When [On (Specify)] is selected, select [Over A0K
KK
K], [Over A1K
KK
K], [Over A2K
KK
K],
[Over A3K
KK
K], or [Over A4K
KK
K] as the original size.
NeptuneC1_GBzen_F_FM_pre.book Page 37 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
