User Tools (System Settings)
38
3
❖
❖❖
❖ Output Tray
You can specify the paper output tray to use when the power is turned on or
the {
{{
{Clear Modes}
}}
} key is pressed.
• Lower
• Upper
Note
❒ Default: Upper
❖
❖❖
❖ Orig. Feed Delay1
You can specify the duration of delay before an original is fed into the ma-
chine after being set. If originals frequently feed in slanted, or you are using
special originals, set the delay accordingly.
Note
❒ Default: 1 sec.
❒ The time can be set from 1 to 5 seconds.
❖
❖❖
❖ Orig. Feed Delay2
You can specify the duration of the pause immediately after originals are first
fed into the machine. If originals frequently feed in slanted, or you are using
special originals, set the delay accordingly.
• On 1 sec.
• Off
Note
❒ Default: Off
❒ Select [On], the time can be set from 1 to 5 seconds.
❖
❖❖
❖ Auto Roll Switch.
If paper roll 1 runs out during copying, the machine can automatically switch
to paper roll 2. This setting specifies whether or not to automatically switch
the paper rolls.
• On
• Off
Note
❒ Default: Off
❒ This function is only available in the paper roll tray.
NeptuneC1_GBzen_F_FM_pre.book Page 38 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
