Settings You Can Change with User Tools
39
3
❖
❖❖
❖ Fine Ratio:Copier
Depending on paper type, environment, and humidity, copy paper can ex-
pand or shrink slightly. This means that the size of the copy and the original
do not match. If this happens, you can specify the vertical and horizontal cor-
rection ratio. You can specify this setting for each paper type (plain, translu-
cent, film)
Note
❒ Default: 0.0%
❒ From –1.0% to 1.0% (in 0.1% increments)
❒ To set the Fine Ratio setting, measure the length of the original and the
copy image to calculate the ratio.
ABB009S
ZEDG010E
Calculating the Correction Value (%)
To copy at the same size as the original
Example)
CopyOriginal
Horiz. Horiz.
... For the example above:
correction value(%)
Set the correction value (horizontal) to 0.8%.
NeptuneC1_GBzen_F_FM_pre.book Page 39 Tuesday, December 16, 2003 5:03 PM
To Next Page
Loading...
