Paper and Other Media
14
1
Loading Paper
This describes how to load paper into
the paper tray and bypass tray.
CAUTION:
Loading Paper in Tray 1 and
the optional paper feed unit
The following example explains load-
ing procedure for the standard paper
tray (Tray 1). The same procedure can
be used for the optional paper feed
unit.
Important
❒ Make sure paper is not stacked
above the limit mark inside the
tray. Misfeeds might occur.
❒ Do not put different types of paper
in a single paper tray.
❒ Up to 500 sheets of paper can be
loaded in the paper feed unit. This
means a maximum of 1,600 sheets
can be simultaneously loaded
when two additional paper feed
units are installed.
A Lift the paper tray slightly, and
then pull it out until it stops.
B Lift the front side of the tray, and
then pull it out of the printer.
C Load paper into the tray with the
print side down.
• Do not pull out the paper tray
forcefully. If you do, the tray
might fall and cause an injury.
AGN029S
ZKGY140E
ZKGY130E
KirP4GB_Mainte-F5_FM_forPaper.book Page 14 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
