Attaching Bluetooth Interface Unit Type C
47
3
Attaching Bluetooth Interface Unit Type C
CAUTION:
Important
❒ When using the printer with the
Bluetooth interface unit installed,
Bluetooth needs to be installed on
the computer.
❒ Before manipulating the Bluetooth
interface unit, touch something
metal to discharge static electricity.
Static electricity can damage the
Bluetooth interface unit.
❒ Do not subject the Bluetooth inter-
face unit to physical shocks.
A Check the package contains the
following:
❖ Bluetooth Interface Unit Type C
•Interface Unit
•Card
• Antenna Cap
B Turn off the power of the printer,
and then unplug the printer's
power cable and the interface ca-
ble.
C If the duplex unit is attached,
push down the lever on right side
( ) and then pull out the duplex
unit until it stops ( ).
If the duplex unit is not attached,
go to the following steps.
• Do not touch inside the controller
board compartment. Doing so
may cause a machine malfunc-
tion or a burn.
ZKDP410J
ZKDP510J
ZKDP900J
ZKGX320E
KirP4GB_Setup-F4_FM_forPaper.book Page 47 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
