Setting Up
24
2
Loading Paper
The following describes how to load
paper into the standard paper tray
(Tray 1).
CAUTION:
Important
❒ To avoid paper jams, make sure
paper is not stacked above the lim-
it mark inside the tray. Misfeeds
might occur.
❒ Do not mix different types of paper
in a single paper tray.
A Lift the paper tray slightly, and
then pull it out until it stops.
Note
❒ Do not touch the three white
pins on the left front of the
printer.
B Lift the front side of the tray, and
then pull it out of the printer.
C Load the new paper into paper
tray with print side up.
Important
❒ Confirm that the top of the stack
is not higher than the limit mark
inside the tray.
❒ Confirm that the paper fits un-
der the rear guides.
• Do not pull out the paper tray
forcefully. If you do, the tray
might fall and cause an injury.
AGN029S
ZKGY140E
ZKGY130E
KirP4GB_Setup-F4_FM_forPaper.book Page 24 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
