Monitoring and Configuring the Printer
205
msh> spoolsw
❖ Job Spool setting
msh> spoolsw spool {on | off}
❒ Specify “on” to enable Job Spool, or “off” to disable it.
❖ Resetting Job spool setting
msh> spoolsw clear job {on | off}
• When the printer power is cut during job spooling, this determines whether
to reprint the spooled job.
❖ Protocol configuration
msh> spoolsw diprint {on | off}
msh> spoolsw lpr {on | off}
msh> spoolsw ipp {on | off}
msh> spoolsw smb {on | off}
msh> spoolsw ftp {on | off}
• You can specify the settings for diprint, lpr, ipp, and smb.
sprint
Use the “sprint” command to make settings for IEEE 1394 (SCSI print).
❖ View settings
IEEE 1394 (SCSI print) settings are displayed.
msh> sprint
❖ Bidirectional configuration for IEEE 1394 (SCSI print)
Use this setting to set IEEE 1394 (SCSI print) bidirectional.
The default is “on”.
msh> sprint bidi {on | off}
status
The printer status can be checked using the following command:
❖ Messages
msh> status
For details, see p.212 “Current Printer Status”.
To Next Page
Loading...
