Configuration
72
5
SCSI print
A Press the {Menu} key.
The [Menu] screen appears on the
display.
B Press the {U} or {T} key to dis-
play [Host Interface], and then press
the {# Enter} key.
The interface setting menu ap-
pears.
C Press the {U} or {T} key to dis-
play [IEEE 1394 Setup], and then
press the {# Enter} key.
The IEEE 1394 setting menu ap-
pears.
D Set [SCSI print] and [Bidi-SCSI print]
if necessary.
Note
❒ The default setting is “Active”.
E Press the {U} or {T} key to dis-
play [SCSI print], and the press the
{# Enter} key.
F Press the {U} or {T} key to select
either [Active] or [Not Active], and
then press the {# Enter} key.
After the settings are made, about
two seconds later, the screen re-
turns to the IEEE 1394 setting
menu.
G Set [Bidi-SCSI print] in the same
way.
H Press the {Online} key.
The initial screen appears.
I Print a configuration page to con-
firm the settings made.
Reference
For details about printing the
configuration page, see p.28
“Test Printing”.
Menu:
Host Interface
AGN200S
SCSI print:
*Active
Ready
KirP4GB_Setup-F4_FM_forPaper.book Page 72 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
