Monitoring and Configuring the Printer
200
slp
Use “slp” command to configure SLP settings.
msh> slp ttl “ttl_val”
• You can search the NetWare server using SLP in the PureIP environment of
NetWare 5/5.1 and Netware 6/6.5. Using the “slp” command, you can config-
ure the value of TTL which can be used by SLP multicast packet.
• The default value of TTL is 1. A search is executed only within a local seg-
ment. If the router does not support multicast, the settings are not available
even if the TTL value is increased.
• The acceptable TTL value is between 1 and 255.
smb
Use the “smb” command to configure or delete the computer or workgroup name
for SMB.
❖ Computer Name settings
msh> smb comp
• Set computer name using up to 15 characters. Names beginning with
“RNP” or “rnp” cannot be entered.
❖ Working Group Name settings
msh> smb group
• Set workgroup name using up to 15 characters
❖ Comment settings
msh> smb comment
• Set comment using up to 31 characters
❖ Notify print job completion
msh> smb notif {on | off}
• To notify print job completion, specify “on”. Otherwise, specify “off”
❖ Deleting Computer Name
msh> smb clear comp
❖ Deleting Group Name
msh> smb clear group
❖ Deleting Comment
msh> smb clear comment
To Next Page
Loading...
