Loading Paper
23
1
C To set the paper size and feed di-
rection, Press the {Menu} key.
The [Menu] screen appears on the
display.
D Press the {U} or {T} key to dis-
play [Paper Input], and then press
the {# Enter} key.
The paper selection menu appears.
E Check [Bypass Size] appears, and
then press the {# Enter} key.
The paper size selection menu ap-
pears.
F Press the {U} or {T} key to dis-
play the size and orientation of
the paper in the bypass tray.
After about two seconds, the dis-
play returns to the menu.
G Press the {Online} key.
The initial screen appears.
Note
❒ To load thick paper, OHP trans-
parencies, or envelopes, make
settings for thick paper or OHP
transparencies using the control
panel and printer driver.
❒ The number of pages that can be
loaded in the bypass tray differs
depending on paper type. Make
sure paper is not stacked above
the paper guides inside the by-
pass tray.
Reference
For details about control panel
settings for custom size paper or
special paper, see p.24 “Specify-
ing custom size paper for the
Bypass Tray”.
For control panel settings when
using thick paper, OHP trans-
parencies, or post cards, see
p.25 “Specifying a paper type
for the Bypass Tray”.
Menu:
Paper Input
Bypass Size:
*A4 (210 x 297)
AGN200S
KirP4GB_Mainte-F5_FM_forPaper.book Page 23 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
