Replacing the Maintenance Kit
43
2
Replacing the fusing unit with the
duplex unit attached
A Push down the lever on the right
side of the duplex unit ( ), and
then pull it out until it stops ( ).
B Lift the lock levers of the fusing
unit as shown in the illustration.
C Pull the fusing unit out.
D Pull out the pins on both sides of
the new fusing unit.
E Replace the new fusing unit into
the printer.
F Push the lock levers of the fusing
unit down until it clicks.
ZKGX320E
AGN006S
AGN007S
ZKGM010E
AGN008S
AGN009S
KirP4GB_Mainte-F5_FM_forPaper.book Page 43 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
