Error & Status Messages on the Control Panel
61
5
Setting changed
Restart Printer
[RAM Disk] or [Notify by E-mail]
setting has been changed.
Restart the printer so the new settings
can take effect.
SSID not entered This message appears if the
SSID has not been entered.
Enter the SSID.
Toner is almost
empty
The toner is almost run out. Prepare a new toner cartridge. If the
image density gets too light, replace
the toner cartridge with a new one.
See p.31 “Replacing the Toner Car-
tridge”.
Update Mode Err.
Power Off On
The printer has failed to start
updating data.
Turn the power off, and then on to re-
start.
Waiting... The printer is waiting for the
next print job.
Wait a while.
Warming up... The printer is warming up or
toner is being supplied.
Wait until the panel display change
the [Ready].
Messages
/Second messages
Description Solution
KirP4GB_Mainte-F5_FM_forPaper.book Page 61 Wednesday, December 8, 2004 6:13 PM
To Next Page
Loading...
