Preparing for Printing
18
B Insert the CD-ROM into the CD-ROM drive.
The installer starts.
Auto Run may not work with certain operating system settings. If this hap-
pens, launch “Setup.exe”on the CD-ROM root directory.
C Select an interface language, and then click [OK].
The default interface language is English.
D Click [PCL/RPCS Printer Drivers].
E The software license agreement appears in the [License Agreement] dialog
box.
After reading the agreement, click [I accept the agreement] , and then click
[Next].
F Select the printer driver you want to use in the [Printer Program] dialog
box.
You can select several printer drivers.
G Select the printer model you want to use.
The printer name can be changed in the [Change settings for 'Printer Name'] box.
H Double-click the printer name to display the printer settings.
❒ The details shown in [Comment:], [Driver:], and [Port:] vary depending on the
operating system, printer model, and port.
I Click [Port:], and then click [Add].
J Click [SmartDeviceMonitor], and then click [New Port...].
K Click [NetBEUI], and then click [Search].
A list of printers using NetBEUI appears.
L Select the printer you want to use, and then click [OK].
Only printers that respond to a broadcast from the computer appear. To use
a printer not listed here, click [Specify address], and then enter the NetBEUI ad-
dress. The NetBEUI address can be checked with the configuration page. For
information about printing a configuration page, see p.131 “
Printing a Config-
uration Page”. The NetBEUI address appears in the format of “\\RN-
Pxxxx\xxx” on the configuration page. Enter the printer's network path in the
format of “%%Computer name\Share name”. Use “\\” instead of “%%” at the
beginning.
M Check that the port of the selected printer is displayed in [Port:].
N Set a user code, if necessary.
To Next Page
Loading...
