Preparing for Printing
71
E To disable Auto Run, press the left {SHIFT} key when inserting the CD-
ROM into the drive and keep it pressed until the computer finishes read-
ing from the CD-ROM.
If Auto Run starts, click [Cancel], and then [Exit].
F Click [Browse].
G Select the printer driver you want to use.
If the CD-ROM drive is D, the source files of the printer driver are stored in the
following location:
•RPCS
D:DRIVESRPCSWIN2K_XP(Language)DISK1
•PCL 5e
D:DRIVESPCL5EWIN2K_XP(Language)DISK1
•PCL 6
D:DRIVESPCL6WIN2K_XP(Language)DISK1
• PostScript 3
D:DRIVESPS3WIN2K_XP(Language)DISK1
H Click [Open].
I Click [OK].
J Follow the instructions.
When installation is complete, the printer connected to “1394_00n” appears
in the [Printers] window. (“n” shows the number of printers connected.)
❒ If the printer driver has already been installed, the printer icon is added to
the [Printers] window. In this case, printer driver installation is not neces-
sary.
❒ If printing does not work properly after the installation, delete the port and
reinstall the printer driver. For details, see “Printer Does Not Print”, Main-
tenance Guide.
❒ If you do not want to install the printer when Found New Hardware Wizard
starts under an operating system that supports SCSI print, disable the de-
vice by following the procedure below.
A When the [Found New Hardware Wizard] dialog box appears, click [Next >].
B When the message “This wizard will complete the installation for this
Device: Unknown” appears, select the [Search for a suitable driver for my
device [recommended]] check box, and then click [Next >].
C When the message “Please choose your search and installation option.”
appears, clear all check boxes from [Search for the best driver in these loca-
tions.], and then click [Next >].
To Next Page
Loading...
