Setting Up
22
2
A Open the front cover by pushing
the front cover release button.
B Remove the fixing material in-
serted between toner cartridge
and the printer.
C Lift the front side of the toner car-
tridge, and then pull it out of the
printer.
Note
❒
Do not hold the toner cartridge
upside down or stand it vertically.
❒ Do not put the toner cartridge
on an unstable or tilted surface.
D Place the toner cartridge on a flat
surface. Pull out the tape inside
the unit horizontally while hold-
ing the cartridge with one hand as
shown in the illustration.
Important
❒ Be sure to remove the tape com-
pletely before installing the ton-
er cartridge. Otherwise, the
printer might be damaged.
❒ If you pull out the strips when
the toner cartridge is slant or
standing on its side, the car-
tridge might cause trouble with
the printer.
❒ Be sure to pull the tape horizon-
tally. Pulling it upward or
downward may cause the toner
to scatter.
❒ After pulling the tape out of the
cartridge, toner scatters easily.
Do not shake the cartridge.
E Hold the grips of the toner car-
tridge, and then insert it into the
printer until it stops.
AGN020S
AGN019S
AGN022S
ZKGT151E
AGN023S
KirP4GB_Setup-F4_FM_forPaper.book Page 22 Wednesday, December 8, 2004 6:05 AM
To Next Page
Loading...
